提供者：麻城施迈赛工业自动化有限公司 发布时间：2018/5/16 11:59:03 阅读次数：4262次 进入该公司店铺
技术数据：
产品尺寸：M30x1.5
一般说明检测范围80 ... 2000 mm调节范围120 ... 2000 mm盲区
0 ... 80 mm
标准目标板100 mm x 100 mm换能器频率约180 kHz响应延时
最小65 ms
出厂设定195 ms
工作方式/显示方式LED 绿色常亮：通电
闪烁：待机模式或设定状态下检测到目标物LED 黄色1常亮：开关状态开关输出1 闪烁：设定功能
LED 黄色2常亮：开关状态开关输出2 闪烁：设定功能
LED 红色常亮：温度/设定插头未连接
闪烁：出错或设定状态下未检测到目标物温度/设定插头温度补偿，开关点设定，输出功能设定电气参数工作电压10 ... 30 V DC,纹波10 %PP空载电流I0≤ 50 mA
接口接口类型RS 232, 9600 Bit/s,无奇偶校验, 8数据位, 1停止位输入/输出同步
双向
0-level: -UB ... +1 V1-level: +4 V ... +UB输入阻抗: > 12 kΩ
同步脉冲: ≥ 100 μs,同步脉冲周期: ≥ 2 ms同步频率
一般操作模式≤ 30 Hz
多重操作模式≤ 30/n Hz, n =传感器数量
输出输出类型2个开关量输出pnp,¨NO/NC可选重复精度
≤ 0.1 %满量程值
额定工作电流Ie
200 mA,短路保护/过载保护电压降Ud≤ 2.5 V开关频率f≤ 2.5 Hz
迟滞范围 H 可调整开关距离的1 %（缺省设置），可调温度漂移≤满量程值的2 %（带温度补偿）≤ 0.2 %/K（不带温度补偿）符合标准标准IEC / EN 60947-5-2周围环境环境温度-25 ... 70 ºC (248 ... 343 K)储存温度-40 ... 85 ºC (233 ... 358 K)机械特性防护等级IP65
连接方式V15连接器( M12 x 1), 5针
材料外壳 不锈钢 1.4303塑料部分PBT
英文参数表（English parameter list）：
| General specifications | ||
|---|---|---|
| Sensing range | 80 ... 2000 mm | |
| Adjustment range | 120 ... 2000 mm | |
| Dead band | 0 ... 80 mm | |
| Standard target plate | 100 mm x 100 mm | |
| Transducer frequency | approx. 180 kHz | |
| Response delay | 65 ms minimum 195 ms factory setting | |
| Indicators/operating means | ||
| LED green | solid: Power-on flashing: Standby mode or program function object detected | |
| LED yellow 1 | solid: switching state switch output 1 flashing: program function | |
| LED yellow 2 | solid: switching state switch output 2 flashing: program function | |
| LED red | solid: temperature/program plug not connected flashing: fault or program function object not detected | |
| Temperature/TEACH-IN connector | Temperature compensation , Switch points programming , output function setting | |
| Electrical specifications | ||
| Operating voltage | 10 ... 30 V DC , ripple 10 %SS | |
| No-load supply current | ≤ 50 mA | |
| Interface | ||
| Interface type | RS 232, 9600 Bit/s , no parity, 8 data bits, 1 stop bit | |
| Input/Output | ||
| Synchronization | bi-directional 0 level -UB...+1 V 1 level: +4 V...+UB input impedance: > 12 KOhm synchronization pulse: ≥ 100 µs, synchronization interpulse period: ≥ 2 ms | |
| Synchronization frequency | ||
| Common mode operation | max. 30 Hz | |
| Multiplex operation | ≤ 30 Hz / n , n = number of sensors , n ≤ 5 | |
| Output | ||
| Output type | 2 switch outputs PNP, NO/NC, programmable | |
| Rated operating current | 200 mA , short-circuit/overload protected | |
| Voltage drop | ≤ 2.5 V | |
| Repeat accuracy | ≤ 0.1 % of full-scale value | |
| Switching frequency | ≤ 2.5 Hz | |
| Range hysteresis | 1 % of the adjusted operating range (default settings), programmable | |
| Temperature influence | ≤ 2 % from full-scale value (with temperature compensation) ≤ 0.2 %/K (without temperature compensation) | |
| Approvals ａnd certificates | ||
| EAC conformity | TR CU 020/2011 | |
| UL approval | cULus Listed, General Purpose | |
| CSA approval | cCSAus Listed, General Purpose | |
| CCC approval | CCC approval / marking not required for products rated ≤36 V | |
| Ambient conditions | ||
| Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) | |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) | |
| Mechanical specifications | ||
| Connection type | Connector M12 x 1 , 5-pin | |
| Degree of protection | IP65 | |
| Material | ||
| Housing | stainless steel (1.4305 / AISI 303) PBT plastic parts | |
| Transducer | epoxy resin/hollow glass sphere mixture; polyurethane foam | |
| Mass | 140 g | |
① 凡本网注明"来源：阿仪网"的所有作品，版权均属于阿仪网，未经本网授权不得转载、摘编或利 用其它方式使用。已获本网授 权的作品，应在授权范围内使用，并注明"来源：阿仪网"。违者本网将追究相关法律责任。
② 本信息由注册会员：麻城施迈赛工业自动化有限公司发布并且负责版权等法律责任。
版权声明